Download cmotion User`s Guide

Introduction: Using The User’s Manual
Note: Notes are used to indicate important information for the user that
pertains to the respective section of this user’s guide.
Warning: Warnings are used to indicate important information for the user that
pertains to the respective section of this user’s guide and where something could
go wrong in the process or damage to units could be caused.
camin, coperate, czoom:
All cmotion components are written in cursive
throughout this user’s manual. These words can all also be found at the back of
this user’s manual.
Cables
When a cable is referred to in this user’s manual it will be referred to as follows
(e.g. FI 12p, LE 7p). Cables are referred to in reference to their connectors.
Cmotion cables are manufactured by W. W. Fisher, Lemo or Hirose which will be
referred to as FI, LE and HI respectively. The cable identification begins with the
connector that is connected to the cmotion unit, a comma follows, followed by
the connector which is connected to non-cmotion units; each connector takes
reference to the number of pins it has e.g. the cable (FI 12p, LE 7p) cable is the
cmotion Scorpio motor cable. The FI 7p connector is connected to the camin and
the LE 12p connector is connected to the Scorpio motor. Cables may also be
referred to by their commonly used names e.g. CBUS (FI 7p, FI 7p) and RS (FI
3p, FI 3p) cables, the cable for the CBUS interface and the cable for the RS
interface, respectively.
Necessary Tools
The following tools may be required to complete steps laid out in this user’s
manual:
4mm Allen key