Download Using the LAN

typing it again and pressing Enter. You can set the supervisor/user password
to be required for starting up the system and/or entering BIOS Setup.
Password on Boot allows you to enable or disable the entering of password
for booting up your system. Once the password is successfully set and this
item is enabled, it is required for booting up the system.
Set HDD 0 Password sets the password for locking the Primary Master hard
disk drive. After setting a password, the hard disk drive can only be
unlocked by the password no matter where it is installed.
HDD 0 Password Is shows whether you have set the hard disk password or
not.
TPM Setup sets various TPM parameters. Press Enter to access the submenu
as shown below.
Information
Main
Advanced
Security
Boot
TPM Setup Menu
TPM Support
[Enter
Enabled]
Current TPM State:
Change TPM State
Disabled & Deactivated
[No Change ]
F1 Help
Esc Exit
↑↓ Select Item
←→ Select Menu
Exit
Item Specific Help
Enable Trusted Platform
Module support
-/+
Change Values
Enter Select X Sub-Menu
F9 Setup Defaults
F10 Save and Exit
TPM Support enables or disables TPM support (see chapter 6 for details).
Current TPM State shows the current TPM state.
Change TPM State allows you to select between No Change, Clear,
Deactivate & Disable, and Enable & Activate.
5-12
Using BIOS Setup and System Recovery