Download User`s Manual - Versa Technology

For a cluster in Daisy Chain topology, each IPDSLAM must have one GBE port
configured as Uplink and the other one configured as User link.
From the System menu, click on Cluster Setup. The following page is displayed:
By default, the DSLAM is not in a cluster. The state of the Cluster Configuration shows
“IDLE” and the Role shows “Individual”.
To make the DSLAM join a cluster, select the Role as “Cluster” or “Slave only” according to
your plan and then click on Modify. The state of the Cluster Configuration will show from
DISCOVERING to VOTING to MASTER or SLAVE at last.
The following figure shows the Cluster Setup page of a cluster containing two cluster
members. You will see the following page if you’re connecting directly to the Master via its
in-band/ out-band IP address or connecting to the Cluster IP “172.31.1.1”. You can control
all the DSLAMs in a cluster by connecting to the Cluster IP address, or by directly
connecting to the Master IPDSLAM via its in-band or out-band IP address that is configured
in the Board IP Setup page.