Download DVD case Manual INT & EXT.ai
Transcript
Cautions Set up as instructed on this manual interior. Do not use DVD Player Case for any other purpose than to hold DVD player. Only use DVD Player case in back seat of vehicle for passenger viewing. DVD PLAYER CASE for use with DVD players up to 9ll Always keep DVD player strapped into case. Do not let straps or hooks interfere with driver. Thank You We appreciate your use of this fine USA GEAR product and wish many happy hours of comfortable entertainment. ACCESSORY POWER WESTLAKE VILLAGE, CALIFORNIA WWW.ACCESSORYPOWER.COM MADE IN CHINA USER MANUAL MODEL GEAR-DVD1 Behind one seat setup Between two seats setup 1) Unzip and open the case. Position the case as shown in PHOTO (A). The case handle should face the viewer. 2) Remove two straps from inside the case. Note that the straps are adjustable to allow for custom fit in most vehicles. 3) Clip a hook from each strap to top rings. 4) Wrap each strap around the headrest so they cross on the opposite side, see PHOTO (B). Pull the straps through the inside of the headrest support posts, as seen below. 5) Bring the ends around and clip them to the front rings of the bottom portion of case. 6) Place DVD player in bottom tray and secure with fastener strap inside of bottom tray. PHOTO (A) Top ring Fastener strap PHOTO (B) 1) Unzip and open the case. Position the case as shown in PHOTO (C). Handle should face the viewer. 2) Remove two straps from inside the case. Note that the straps are adjustable to allow for custom fit in most vehicles. 3) Clip a hook from each strap to top rings. 4) Extend a strap to one headrest. Wrap the strap around the headrest support post, as shown below, and back toward the bottom portion of case. 5) Clip the hook to the front ring of the bottom tray. 6) Repeat steps 4 and 5 on other headrest. 6) Place DVD player in bottom tray and secure with fastener strap inside of bottom tray. PHOTO (C) Support post Top ring Opposite side of headrest Front ring Fastener strap Front ring