Download User`s Manual

HPX10 User’s Manual
IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS - This manual contains important safety and operating
instructions for Model HPX10 Battery Chargers. Before using the battery charger, please
read all instructions and cautionary markings on the battery charger, the battery, and the
product using the battery.
CAUTION - To reduce the risk of electric shock:
o Do not expose unit to rain or moisture.
o Do not remove cover. There are no user serviceable parts inside. Refer service to
qualified service personnel.
o Connect the battery charger directly to a grounding receptacle. An adaptor
should not be used with this unit. This unit is equipped with a power plug having
an equipment grounding conductor (3-prong). The unit must be plugged into an
outlet that has been properly installed and grounded in accordance with all local
and national codes and ordinances.
o Disconnect charger from AC power and battery before attempting any
maintenance or cleaning. Turning off controls may not reduce this risk.
WARNING
o Charge only sealed or valve regulated, lead-acid, non-automotive, maintenance
free rechargeable batteries. Attempting to charge other types of batteries may
result in personal injury and battery damage.
o The enclosure (metal face) may become hot during the charge cycle - DO NOT
TOUCH!
o Where hydrogen gas may be present, connect or disconnect the output
connectors only when the unit is disconnected from AC power or arcing and
burning may result.
DANGER - Never alter power plug blades or ground pin. If it will not fit the outlet, have
a proper outlet installed by an electrician. Improper connection will result in the risk of an
electric shock or fire.
Make sure cords are located so that they will not be stepped on, tripped over, or otherwise
subjected to damage or stress. Do not operate this unit with a damaged cord or plug replace them immediately. To reduce the risk of damage to electric plug, pull by unit
body rather than output cord when disconnecting unit.
Do not operate charger if it has received a sharp blow, been dropped, or otherwise
damaged in any way. Do not disassemble charger; incorrect reassembly will result in the
risk of an electric shock or fire. Refer service to qualified service personnel.
Allow space around unit and adequate air circulation to reduce internal heat buildup. Do
not block vents or operate in a small, enclosed space.
Xenotronix/TLI
1