Download Motion Application Program CNC User Manual

If any Jump commands or similar that require a specific line number are used in the
program and are below the deleted line, the operator will be prompted to
automatically adjust these numbers or leave as they are.
Display Registers and Graph
By pressing the corresponding key, a pop up menu will be drawn as follows:
The user can scroll down between the options using the UP and Down keys and press
ENTER to select an option.
Display Registers
Will show on screen the current value stored on each Register. Using the up and
down arrows the user can scroll through the 256 registers.
Display Origins
This will display a small pop-up box with the x,y,z origins that have been set for the
edges of the part to be machined.
Display Trace Buffer
This feature shows the sequence of lines that have last been run. This is useful in
debugging a program as you cannot always see where a jump has actually gone to or
which condition was met. This is a circular buffer and gets overwritten and so only
shows the last 256 lines run.
62 of 70
Sept 2014