Download CC-Link Safety System Remote I/O Module User`s Manual

PARAMETER SETTING
1
This parameter is used to set the OFF pulse width used in the output dark test in the
output point unit.
The settings are shown in Table5.8.
Table5.8 Settings of “Output dark test pulse OFF time”
range
Default
ÉSYSTEM
CONFIGURATION
34. Output dark test pulse OFF time Y0
35. Output dark test pulse OFF time Y1
36. Output dark test pulse OFF time Y2
37. Output dark test pulse OFF time Y3
Setting
400 s
1ms
2
400 s
2ms
3
When a value out of the setting range is set, an error out of the setting range of
"Output dark test pulse OFF" occurs.
For details of the error, refer to Section 9.5.
SPECIFICATIONSl
Parameter item
OVERVIEW
(3) Output dark test pulse OFF time
FUNCTIONS
4
PARAMETER
SETTING
5
PROCEDURES AND
SETTINGS BEFORE
SYSTEM OPERATIO
6
PROGRAMMING
7
8
MAINTENANCE AND
INSPECTION
5
5.2 Parameter Details
5.2.2 Output parameter
5 - 18