Download Installer Manual

Transcript
ET Wingo 2015.001.105 – Installer instructions
Determining the Motor Mounting Positions and Installing the Motors.
There is one common factor in all swing gate applications that is unchanging. This factor is the hinges that the gates swing on.
No matter the column, style, post or wall that the hinges are fastened to, the gate will always swing on these fixed pivot
points. For this reason we take all of the measurements necessary to determine the gate motor positioning from the hinge
centers.
The origin line “A” is the shortest distance between the hinge centers “H” on either side of the driveway.
When the gates are closed, they form the origin line.
The inset line “B” is the line, which is inset into the property, that the motor head pivot points will line
up on. The inset line should always be parallel to the origin line. In the case of the Wingo motors the
inset line can be between 180 and 230 mm from the origin line.
The origin line and inset line are the same in both inward opening gate and outward opening gate applications.
Once you have found your origin line and you have measured and marked your inset line, you can continue on to the next step
in determining your motor mounting positions.
9