Download Attachment - Alpha Omega

STEP 11
STEP 12
(Boring Bar Set Up)
(Drum Mounting)
(for Machining Drum)
If necessary, remove the Twin Cutter Assembly.
1. Clean the surface of the Hubless adapter.
1. Clean the Cross Feed mounting Surface.
2. Mount the proper size backing plate onto the Hubless
Adapter.
2. Loosely mount the Drum Tool Bar Assembly.
3. Remove any debris from the drum.
3. Be sure that a proper tool bit is secure in the Boring bar
and the cutting tip is not excessively worn. Sharp cutting
tips must be used at all times. A dull cutter will affect the
finish of both drums and rotors. If the cutting edge is
damaged, replace it promptly. Be sure no metal chips are
under tip when changing tips.
4. Mount the drum onto the arbor.
5. Mount the Centering Cone.
26