Download "user manual"

IP Sharing Mode
When enabled, PCs connected to the LAN2 port will be able to access the
WAN/LAN1.
Link Aggregation
Specifies whether WAN/LAN1 and LAN2 ports will be aggregated and act as
one port. There are 6 modes can be choose from:
Load Balance/Fail-over/Balance-XOR/802.3ad/Balance-TLB/Balance-ALB
Set IP Address by:
Static / Dynamic
IP
You can choose a static IP or Dynamic IP, and input your network
configuration
IP address of the WAN/LAN1 interface.
Netmask
Gateway
Network mask, which is generally: 255.255.255.0
Default Gateway IP address.
DNS Server
Domain Name Service (DNS) server IP address.
NOTE
• Only use Jumbo Frame settings when operating in a Gigabit environment
where all other clients have Jumbo Frame Setting enabled.
• If you are only using the WAN/LAN1 port, we suggest that you disable IP
Sharing Mode. This will result in higher throughput.
• A correct DNS setting is vital to networks services, such as SMTP and NTP.
• To use the Link Aggregation with “802.3ad selected” feature, please make sure
the networking equipment on the other end of Ethernet cable also supports
802.3ad protocol.
WARNING
Most Fast Ethernet (10/100) Switches/Routers do not support Jumbo Frame and you will not
be able to connect to your N8900/N12000/N16000 after Jumbo Frame is turned on.
LAN2
LAN2 Configuration
The Thecus IP storage supports two Gigabit Ethernet ports for higher service
availability. To configure these ports, choose LAN2 from the System Network
menu, and the LAN2 Configuration screen appears. Press Apply to save your
changes.
37