Download User manual

Setting-up the communication parameters
2.2.2
Setting-up the properties in HyperTerminal
Configure HyperTerminal according to the application ("File → Properties"). The configuration is only
possible if the connection is inactive. If necessary, an active communication has to be disconnected via
"Call → Disconnect" first.
Note
Please note that the configuration for the RS232-module and for the HyperTerminal are
identical. Otherwise an error-free communication can not be guaranteed.
Figure 2-5:
Windows
HyperTerminal,
configuration
D301146 - CoDeSys FBs for BL×× 1012
2-5