Download Exterior 1200 Image Projector specifications

Luminaire settings
To access the luminaire settings using MUM, click on the Fixture settings button.
DMX ad dre ss, DMX L amp Off an d DMX Rese t se ttin gs
If you intend to operate the Exterior 1200 Image Projector with a DMX controller, the DMX
address must be set on all luminaires for which individual control is required. If you are not
familiar with the principles of DMX addressing in an installation with multiple fixtures, see
"7.1.1: Setting DMX addresses" on page 45.
It is also a good idea to set the DMX Lamp Off and DMX Reset options. These settings
are described in "7.1: Preparing for DMX control" on page 45.
The other default luminaire settings listed below are suitable for most applications, and it
may not be necessary to change them.
Automatic lamp on
When the Automatic Lamp On personality is On (the default setting), the luminaire turns
on the lamp within 90 seconds of power on. When set to Off, a lamp-on command is
required to turn on the lamp.
5 . 1 . 2 S e t t i n g u p a l u m i n ai r e w i t h t h e o n b o a r d
c o n t r o l p an e l
See "Onboard control panel menus" on page 75 for an overview of the menus in the
onboard control panel.
32
Exterior 1200 Image Projector user manual