Download User Manual - American Control Electronics

Transcript
PWM Series
Starting and Stopping Methods

!
WARNING!
Dynamic braking, coasting to a stop, or decelerating to minimum
speed is recommended for frequent starts and stops. Do not use
any of these methods for emergency stopping. They may not stop
a drive that is malfunctioning. Removing AC line power (both
lines) is the only acceptable method for emergency stopping.
For this reason, ACE strongly recommends installing an emergency
stop switch on both AC line inputs (see Figure 4 on page 12).
Frequent starting and stopping can produce high torque. This
may cause damage to motors, especially gearmotors that are not
properly sized for the application.
Automatic Restart Upon Power Restoration
All drives automatically run to set speed when power is applied and the
inhibit is not active.
Line Starting and Stopping
Line starting and stopping (applying and removing AC line voltage) is
recommended for infrequent starting and stopping of a drive only. When
AC line voltage is applied to the drive, the motor accelerates to the speed
set by the speed adjust potentiometer or analog signal. When AC line
voltage is removed, the motor coasts to a stop.
15