Download INSTALLATION USER MANUAL

Transcript
Installing KNEEBLOCK or POMMEL as an Accessory
 To install either type of Mount it will be necessary to remove the Velcro
attached Seat Cushion to give improved access to the mounting holes located
at the front /centre of the Seat Base panel.
 Insert the two M6 x 16mm counter-sunk screws supplied, through the holes
from the top and secure either type of Mount by means of the two special keyway retaining Nuts which engage into the Mount slots, (see Figs.15a & 15b).
Fig.15b
Fig.15a
KEYWAY NUTS
KEYWAY NUTS
 Adjustments to the Kneeblock or Pommel height, can be made by slackening
the M8 draw-bolt (s) located at the bottom of the vertical mounting stem,
(Figs.13 & 14). Set the Kneeblock Cups or Pommel Pads to the height
required and secure by re-tightening bolt (r) sufficient to maintain the required
height.
 Positional adjustment of Knee Cups or Pommel Pads, including any
asymmetric settings (see Figs.16a & 16b) on Page 14.
NOTE: The Ratchet type Receiver Mount must be fitted as shown in (Fig.15a),
with the Ratchet Release Lever to the right-hand side.
The “Pop-Pin” Receiver Mount must be fitted as shown in (Fig.15b), with the TriKnob on the right-hand side.
Ensure the key-way Nuts (see Figs. 15s & 15b) are located correctly in their slots
when tightening the securing screws. Tighten screws sufficient to prevent any
movement of the Receiver Mount.
[Cont]
Page 13