Download User Manual - Silentaire

SILENTAIRE
TECHNOLOGY
Scorpion FS-MA 1000A
Single Piston Compressor
8614 Veterans Memorial.
Houston, Texas, 77088
832/327-7452
800/972-7668
Fax: 832/327-0668
E-mail: [email protected]
Thank you and congratulations on the purchase of your SCORPION compressor.
The SCORPION is built to the highest quality standards which produce excellent
efficiency. If you use it properly and maintain it according to this manual, it will
perform to your fullest satisfaction for many years to come. Please read this
manual, carefully and follow the instructions, it will guarantee you a troublefree
operation.
A.
Installation
1.
2.
3.
B.
After taking your SCORPION compressor out of its packaging,
please check it carefully for any damages due to shipping.
Install the compressor on a flat surface in a suitable sized, dry room
with good ventilation, where the temperature is not likely to rise
above 94 Degrees Farenheit (35 Centigrades).
Dispose of the packing material in compliance with the regulations
in the country or state where the compressor is installed.
Safety
1.
2.
3.
Do Not use the OILLESS compressor for purposes other than those
for which it has been designed.
Do Not modify or repair the compressor while it is connected to the
electric current.
Note: The electric outlet has to be properly installed and grounded!
This "bolt of lightning" indicates uninstalled material within your
unit may cause an electrical shock. For the safety of everyone
please do not remove product covering.
The "exclamation point" calls attention to features for which you
should
read the enclosed literature closely to prevent operating and
maintenance problems.
WARNING: TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS EQUIPMENT TO RAIN OR
MOISTURE..
8614 Veterans Memorial.
Houston, Texas, 77088
832/327-7452
800/972-7668
Fax: 832/327-0668
E-mail: [email protected]
C.
Operating Instructions
1.
2.
Connect the equipment for your application to the outgoing ¼” male
fitting at the front of the cylinder head. To keep the connecting
fitting from leaking air you should always applpy Teflon Tape to the
thread of the fitting.
When the compressor gets hot from constantly producing
compressed air, it automatically shuts off. After waiting for about
20 minutes to cool down, it will start working again.
8614 Veterans Memorial.
Houston, Texas, 77088
832/327-7452
800/972-7668
Fax: 832/327-0668
E-mail: [email protected]
EXPLODED VIEW AND PARTS LIST FS-MA-1000 A
8614 Veterans Memorial.
Houston, Texas, 77088
832/327-7452
800/972-7668
Fax: 832/327-0668
E-mail: [email protected]
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
121
122
123
124
125
126
127
128
129
130
131
132
133
134
135
Motor
Front Case
Front Cover
Capacitor & On/Off Switch
Rod
Ball Bearing
Crankshaft
Screw
Inlet & Exhaust Plate
Screw
Cylinder
Compression Ring
Collar
Cylinder Base
O-Ring
Valve Plate Set
O-Ring
Cylinder Head
Adjustable & Release
Valve
Nut
Handle
Handle Screw
Connector
Water Filter
Connector
Nut for Air Hose
Air Hose
Nut forAir Hose
Connector
Elbow
Pressure Switch
Screw
Screw
Screw
8614 Veterans Memorial.
Houston, Texas, 77088
832/327-7452
800/972-7668
Fax: 832/327-0668
E-mail: [email protected]