Download User Manual - Richmond Scientific

20.1.4. Cooperation with E2R
E2R is a control system, it controls all weighments performed on a
balance. Upon activation of this option, operations on some Databases
are possible only with the use of a computer (options are not
accessible on a balance). In order to start cooperation with E2R
system set <YES> value of <E2R SYSTEM> parameter.
Caution:
< E2R System> parameter activation may be carried out by the device
manufacturer or authorized persons, exclusively.
20.2
Printer
Submenu <PRINTER> allows the user to choose a port and a device, to which the
data is to be sent upon pressing
button on balance. Content of data being
transferred is set in parameter <PRINTOUTS/PRINTOUT GLP>.
Procedure:
−
−
−
−
press
button
enter the menu <P4 DEVICES>
enter menu group<P4.2 PRINTER>
set balance parameters related to cooperation with the printer
<P4.2.1PORT> to which the printer is to be connected
Accessible options:
COM 1 or COM 2 – RS 232 port, to which the printer is connected
USB type A – USB port, to which PCL printer or EPSON printer is
connected
WIFI –WIFI port, which can send data to special software
manufactured by NAPIER e.g. WIN measurement, run by means
of the computer connected to the balance via WIFI.
USB flash drive –USB port type A, to which external memory flash
drive is connected
USB PC –USB port type B, to which the computer with the special
software by NAPIER is connected e.g. WIN measurement
Example of the measurement printout is described in the PRINT-OUTS section.
Additionaly the user can send a controlling code (of a hexadecimal form) to a printer
either at the beginning of the printout - <P4.2.2 PREFIX> or at the end of it <P4.2.3 SUFFIX>. Sending these codes allows to control globally both, information
- 151 -