Download Manual - ElliptiGO
Transcript
If your brakes are not working properly, do not ride the ElliptiGO bike. Instead, take your bike to a professional bicycle mechanic to have the brakes adjusted. 12. Ensure that each end of the handlebar is capped with a smooth surface. A handlebar end can have sharp edges that, if exposed, can cut a rider or exacerbate injuries sustained during a fall. WARNING! Improper brake alignment and functioning can result in the rider losing control of the ElliptiGO bike and suffering a fall, which can result in significant injury or death. Always make sure your brakes are working properly before riding. 13. Actuate the gear shifter, shifting up and down to ensure the gear shifter is shifting smoothly in both directions. 9. Thoroughly inspect the steering column to ensure that all components are properly aligned and the quick release levers on the collar are securely fastened. See Section II. 2. G. 2 Adjustable Steering Height for details on how to properly adjust steering column components. See Section III. 1. A. Quick Release Clamping Systems for details on how to ensure the quick release is securely fastened. WARNING! Failure to properly secure the steering column could result in the unexpected collapsing of the steering column during riding. This would likely cause the rider to lose control of the ElliptiGO bike and suffer serious injury or death from a resulting fall. 10. Ensure that the handlebars are aligned properly with the front wheel and that the steering extender quick release is securely fastened. See Section III. 1. A. Quick Release Clamping Systems for details on how to ensure the quick release is securely fastened. WARNING! Failure to secure the steering extender quick release properly could result in an unexpected rotation, collapsing or removal of the steering extender during a ride. This could cause the rider to lose control and suffer a fall, resulting in significant injury or death. 11. Test the grips and bar ends (if any) on the handlebars. They should be in good condition and securely fastened so that they cannot be rotated. Improperly secured grips and bar ends can detach from the handlebars during riding and cause the rider to lose control and fall. 14. Inspect each load wheel to ensure that there are no cracks or chips and it operates properly. Spin each one individually so you can see and feel the entire circumference of the wheel. Check each guide track to make sure that it is free from debris. WARNING! A cracked load wheel can come apart while riding, causing the drive arm to get jammed and resulting in a fall. IF YOU FIND A CRACK IN YOUR LOAD WHEEL DO NOT RIDE YOUR ELLIPTIGO UNTIL THE LOAD WHEEL HAS BEEN REPLACED. Contact [email protected] for replacement load wheels and instructions for how to replace them. 15. BY PLACING YOUR HAND ON THE FOOT PLATFORM rotate the drive mechanism to ensure it is functioning properly. CAUTION! NEVER GRAB THE REAR OF THE DRIVE ARM as your hand can get caught between the drive arm and the cranks and suffer an injury 16. Visually inspect each drive arm carefully to ensure each has no visible signs of damage, especially cracking. Make sure you inspect both to the top and bottom of each drive arm. If a drive arm has visible signs of damage or cracking, DO NOT RIDE the bike. Instead, contact our service department at [email protected] for support. WARNING! Some ElliptiGO bikes are equipped with drive arms made from a composite material commonly known as carbon fiber. Although it is a strong and light material, when it fails, it tends to fail catastrophically and with little or no warning. As a result, it is extremely important to inspect the drive arms thoroughly before riding to ensure that there are no signs of cracking. If you spot damage on a drive arm, DO NOT RIDE the bike. Instead, contact our service department at [email protected] for support. Bike Owner's Manual 21