Download ESABASE2 - Framework Software User Manual

Parameter Type
vec
Range
Default Description
vector not parallel with any
n/a
axis of rotation of the
degree(s) of freedom of
the body
Table 3.4:
specifies a pointing vector
The "VEC1" parameter
VEC1 may be specified only if:
"VEC1" must be followed by at least one "pdir" specification.
"VEC1" must be specified if and only if the current body:
is the central body,
is not the central body and has 2 rotational degrees of freedom,
is not the central body, has 1 rotational degree of freedom, and is attached to its'
parent body using "Inherit parent values".
"VEC1" may not be specified if one other body is attached to the current body using
"Inherit parent values".
3.4.2.4 VEC2
This parameter specifies a vector in the body reference frame that will be aligned with the
required pointing direction, and with VEC1.
Parameter Type
vecb
Range
Default Description
vector not parallel with any axis of
rotation of the degree(s) of
freedom of the body
Table 3.5:
specifies the additional
pointing vector of the
central body
The "VEC2" parameter
The following restrictions apply:
"VEC2" may only be used for the central body (the "System").
Bodies may no longer be attached to the central body using "Inherit parent values".
"VEC2" may be specified only if:
"VEC2" is followed by the corresponding "pdir" specification
"VEC1" is specified.
ESABASE2 - Framework
Date:
Software User Manual
Revision:
1.8.2
Reference: R077-230rep_01_08_02_Software_User_Manual_Framework.doc
State:
Final
etamax space GmbH . Frankfurter Str. 3D . 38122 Braunschweig
2013-07-23
Page 107 / 176