Download Liebert APS UPS user manual
Transcript
Troubleshooting Table 23 Alarm message list (continued) Possible Cause Alarm Message 5.2 Corrective Action Charger Module LOCK Lever in Remove Position The locking lever is not in the locked position. Check the locking lever to ensure it is fully inserted. If so, contact your local Liebert Service representative. Charger Module Fan Failure One or more of the charger module fans has failed. Check to see if the fan is blocked. If not, contact your local Liebert Service representative. Charger Module Temperature Warning One or more charger modules is operating at an internal high temperature. Check the air filters located behind the bezels and clean if necessary, or check to see if the ambient temperature is too high. If this is not the problem, contact your local Liebert Service representative. Module Troubleshooting The power, battery, charger, system control and system monitor module have two LEDs each to indicate the module operating state. Figure 70 shows the location of these LEDs; the meaning of the LED indicators is detailed in Table 24. Figure 70 Module LED location Green Status LED Green Status LED Yellow Fault LED Yellow Fault LED Battery Module Power Module Green Status LED Yellow Fault LED Table 24 System Control Module and System Monitor Module Descriptions of module LEDs Green Status LED Yellow Fault LED Descriptions of Module State Off Off The module is not inserted into the frame, lock lever is in unlocked position or the system is off Off On The module is initializing (maximum 30 seconds 1) Flashing Off Flashing Flashing Flashing On Off Flashing On Off On On On Flashing The module is operating normally The module is in startup mode or the module has an alarm 2 The module is faulty and off-line, and the control module is operating The module is not operating correctly, re-insert the module. If this persists, contact technical support personnel. 1. If this condition persists for more than 30 seconds, verify that the lock lever is in the locked position; if it is not, the module is faulty. 2. If both green and yellow LEDs are flashing for more than 30 seconds, reinsert module. 63 Liebert® APS™