Download Moxa Managed Ethernet Switch User`s Manual

Transcript
Managed Switch Manual (UI 2.0)
Featured Functions
You may add or remove IP addresses to limit access to the Moxa switch. When the accessible IP list is enabled,
only addresses on the list will be allowed access to the Moxa switch. Each IP address and netmask entry can be
tailored for different situations:
•
Grant access to one host with a specific IP address
For example, enter IP address 192.168.1.1 with netmask 255.255.255.255 to allow access to 192.168.1.1
only.
•
Grant access to any host on a specific subnetwork
For example, enter IP address 192.168.1.0 with netmask 255.255.255.0 to allow access to all IPs on the
subnet defined by this IP address/subnet mask combination.
•
Grant access to all hosts
Make sure the accessible IP list is not enabled, by removing the checkmark from Enable the accessible IP
list.
The following table shows additional configuration examples:
Hosts That Need Access
Input Format
Any host
Disable
192.168.1.120
192.168.1.120 / 255.255.255.255
192.168.1.1 to 192.168.1.254
192.168.1.0 / 255.255.255.0
192.168.0.1 to 192.168.255.254
192.168.0.0 / 255.255.0.0
192.168.1.1 to 192.168.1.126
192.168.1.0 / 255.255.255.128
192.168.1.129 to 192.168.1.254
192.168.1.128 / 255.255.255.128
Authentication Certificate
SSL Certificate Re-generate
Setting
Description
Factory Default
Select/Deselect
Enable the SSL Certificate Re-generate
Deselect
Setting
Description
Factory Default
Select/Deselect
Enable the SSH Key Re-generate
Deselect
SSH Key Re-generate
IEEE 802.1X
The IEEE 802.1X standard defines a protocol for client/server-based access control and authentication. The
protocol restricts unauthorized clients from connecting to a LAN through ports that are open to the Internet,
and which otherwise would be readily accessible. The purpose of the authentication server is to check each
client that requests access to the port. The client is only allowed access to the port if the client’s permission is
authenticated.
Three components are used to create an authentication mechanism based on 802.1X standards:
Client/Supplicant, Authentication Server, and Authenticator.
3-67