Download 1999 dtm mtb

ESP REAR DERAILLEUR
INSTALLATION
REAR DERAILLEUR ANATOMY
1
®
b-adjust screw
frame hanger bolt
5 mm
70 – 85 in-lb.
7.9 – 9.6 Nm
cable anchor washer
limit screws
guide pulley
cable guides
cable anchor bolt
COMPATIBILITY
2
ESP 5.0
ESP 7.0
Shifters
SRAM ® 5.0, 7.0, 9.0, 9.0SL shifters ONLY
Cogsets
7.0, 9.0, 9.0SL use 11-28, 11-30, 12-28, 12-32, 11-32
5.0 use 11-28, 11-30, 14-28
Chains
SRAM Power Chain and Shimano ® HG & IG
Chainrings
22-32-42/44, 24-34-46, 26-36-46/48
Cable
1.1 or 1.2 mm high quality cable
Housing
4 or 5 mm compressionless cable housing
FRAME DIMENSIONS
ESP 9.0
ESP 9.0SL
3
T
T
T
R2
L
R1
D
A X
90˚
12.7 mm ±1 mm
• For optimal ESP rear derailleur
performance, the recommended rear
derailleur hanger length (L) should be
between 28–30 mm.
• For a given L, use the chart below to
determine other ESP rear derailleur hanger
specifications.
DIMENSIONS (mm, except A)
INSTALLATION
2. Check that the b-adjust screw is clear of
the rear derailleur dropout tab.
(Fig. 2 or 3)
• For 9.0, 9.0SL models, check that the
b-adjust washer is properly oriented.
The b-adjust washer allows for a more
accurate chain gap adjustment.
(Fig. 3)
3. Tighten the 5 mm hex hanger bolt to
70 – 85 in-lb. (7.9 – 9.6 Nm).
L
X
A
R1
R2
T
28 6–10 25˚–30˚ 8.5 max 11.5 –13.5 7–8
30 7.5 –10 25˚–30˚ 8.5 max 11.5 –13.5 7–8
4
+
TIP:
Check the rear derailleur hanger alignment.
A bent rear derailleur hanger will result in
inaccurate index shifting. Outboard side
impacts are the most common cause of this
type of damage.
1. Attach the rear derailleur to the frame
rear derailleur hanger. (Fig. 1)
20
Technical information may be enhanced without prior notice. Released 08/98.