Download BERGES

BERGES
Berges electronic • D–51709 Marienheide-Rodt • Tel. 02264/17-0 • Fax 02264/17126
JOG
Motor turns only while the FWD or REV keys are pressed (Displayed
only while JOGGING).
TORQ LIMIT
The output torque of the inverter has reached it’s programmed limit
level.
DYN BRAKE
The Dynamic Brake circuits are helping to decelerate the motor and
load.
HI TEMP
The temperature of the drive is near the maximum limit point.
HI CURRENT
The output current is near the overcurrent cutoff point.
HI VOLTAGE
The voltage on the DC bus is near the high voltage cutoff point.
LO VOLTAGE
The voltage on the DC bus is near the low voltage cutoff point.
SPD SEARCH
Autostart has been programmed to 82-START and the inverter is
attempting to synchronize its output with the motor speed.
IDLE#xx
SIO mode of operation only. The drive is programmed to SIO address
(92-SIOA) = xx. It is awaiting either a program or run command.
LS LOCKOUT
Line Start Lockout. A run command was detected when power was
applied.
MODE
The first three characters on the second line denote the present operating mode of the
inverter:
FWD
A Forward run command has been given.
REV
A Reverse run command has been given.
SET
The inverter is waiting to have, or is having, the running frequency set.
FREQUENCY
The standard display shows the inverter operating frequency in Hertz. This can be custom
tailored to any engineering or machine units by the setting of parameters 84-DISP and
85-UNITS.
LOAD
The last four characters in line 2 display the percentage of maximum continuous inverter
output current that is being delivered. If a custom display is programmed on this line, this
information is not displayed but is still viewable at parameter 15-LOAD.
When the programming mode is accessed by pressing the PROG key for LEVEL 1 or SHIFT
and PROG keys for LEVEL 2 or 3, the above display will appear for one second.
PROGRAMMING ACCESS
PARAMETERS
PROGRAM
Rights
30.10.97
05_GB
Operating manual
ACP 6000SLV — 0.75–55
LEVEL 1
Access
39