Download PDF Flow Manual

Sec.
03
Below the Sink Installation
A. Required Tool List
The following tools are required to install Stream Flow Plus Drinking Water System below the sink:
Installation of Faucet/Spigot
(Stainless Steel Sink):
• 3/8” Reversible electric drill
• 7/16” High speed steel drill bit
• Hammer
• Center punch
• 8” Adjustable wrench
• Pliers or vise grips
• 1/8” High speed drill bit
Installation of Faucet/Spigot
(Ceramic/Porcelain Sink):
• 3/8” Reversible electric drill
• 7/16” High speed steel drill bit
• Hammer
• Center punch
• 8” Adjustable wrench
• Pliers or vise grips
Adapt-a-Valve Installation:
• 8” Adjustable wrench
• Wire cutter or knife
B. Attaching the Adapters to the Housing
Stream Flow Plus models are shipped with all of the adapters and connectors needed for the filter system.
Here is how to connect them to the housing top:
To Connect Straight Adapters:
1. Connect the 1/4” outlet adapter to the outlet opening on the
housing by turning it clockwise. You can tighten it by hand and
then give it one to two more turns with a wrench.
2. Connect the 1/4” inlet adapter to the inlet opening on the
housing by turning it clockwise. Again, tighten it by hand and
then with a wrench.
6
Below the Sink Installation