Transcript
“Preppy” Quick Start Guide 1. Unwrap and check the contents. Select an installation location and route the cables 4. Press 99 from the main screen to access the managers menu. Then using the “yes” key arrow across to “edit Clerk and press enter 2. Connect both ends of the interface cable to PREPPY console and the printer. Each plug is different so therefore can only be connected one way 5. Select a clerk number to edit (between 1 – 99) press enter then using the SMS keypad enter the clerk name and then press enter 7. Make sure that the selected mounting wall is free from dirt and oil before affixing PREPPY with the supplied Velcro tape 3. Connect the DC powerpac to the interface box then connect to mains power and turn on the power 6. Use the same managers menu to adjust both date and time, note when setting am/pm the corresponding buttons are the same keys as yes/no 8. Affix “Preppy” to a solid wall or shelf and tidy up any loose cables using the supplied cable ties Please Note: It is highly recommended that “Preppy” is securely mounted to a solid surface to minimize movement of plugs and cables. Physical damage to plugs and cables is not covered by manufacturers warranty The Printer should never be located where it is vulnerable to spills or heat. A shelf is ideal see illustration for installation tip If you require any assistance setting up your new “Preppy” labeling console please call you local distributor. Contact details are in the supplied user manual or via www.prepsafe.com
