Download DVR Server Operations Manual
Transcript
DVR User’s Manual Video Source Selection Follow the same procedure if more UTP Cameras to CH2, CH3, or CH4 will be installed. NOTE: Do NOT insert both BNC and UTP video sources to the same channel simultaneously, or the video will not function correctly and it may cause the video to look like the figure below. For instance, if a UTP Camera is already installed to channel 1, do not install another camera to the BNC port of channel 1. Bad Video Output Step 3: Plug in the power adapter to the DVR, and the DVR will start to boot. The installation is complete. NOTE: The UTP Board provides power up to 5.5W. If the power consumption of the camera is more than 5.5W, the UTP Board will start beeping. NOTE: The length of each UTP cable should NOT exceed 300 meters (or 984 feet), or it may cause loss or weakening of signal. The following table shows performance at different distances. Distance UTP-Converter Meters / Feet Power Output (W) 0 5.526 Excellent 100 / 328 5.256 Excellent 200 / 656 5.04 Good 300 / 984 4.77 Good Video Quality 59