Download SimpleBGC Software User Manual

1. Overview
1. Overview
With the help of this manual you will learn how to connect, adjust and calibrate in a special environment
the SimpleBGC 32bit controller by BaseCamElectronics.
The main principle of SimpleBGC operation is to compensate undesirable impact on the stabilizable device
with brushless motors in holding mode. Motors are managed with a controller board that receives the
repositioning data from the gyroscopic sensor. Gyroscopic sensor (IMU) shall be mounted together with the
camera to register any undesirable repositioning. Frame sensor can also be used (Frame IMU). Thus data
from two sensors will be used by stabilization board simultaneously for more precise system stabilization.
Introduction
Stabilization system controller board and its software were designed and licenced by BaseCam Electronics.
SimpleBGC stands for Simple Brushless Gimbal Controller — gimbal controller for brushless motors. It is a
high quality stabilization system designed for non-professional as well as professional use.
You can purchase our controller version (http://www.basecamelectronics.ru/store/) or a licensed controller version
from our partners (the list of our official partners is available on our web site:
http://www.basecamelectronics.ru/wheretobuy/). Different manufacturers alter the basic version of the controller
(for example, by adding an integrated Bluetooth component or reducing its size etc.). Please pay attention
to the relevant data sheets published on the corresponding manufacturer's web site.
Individual stabilization controllers are available as well as devices with preinstalled controllers
(http://www.basecamelectronics.com/readytouse/). There are also ready gimbals without electronic stabilization
system. In this case you will need to purchase a controller and install it yourself.
If you decide to assemble a stabilization system yourself, please visit our forum where you can find the
necessary information (http://forum.basecamelectronics.com).
In this manual the original 32bit version of SimpleBGC controller is described as well as the multiplatform
application for its adjustment.
Basic connections
Basic controller connection scheme within the camera gimbal stabilization system is shown in figure 1:
© Basecamelectronics® 2013-2014
3