Download User`s Manual
Transcript
3. Hardware Setup Hardware Setup - Before you start, be sure that the power is turned off. Remove only those screws that are explained. Do not move any other screw. Attaching the CFast Attachment Fittings (1) After inserting a CFast Card, fasten the bundled CFast attachment fittings with a screw. * An attached screw (M3 x 8) Figure 3.1. Attaching the CFast Attachment Fittings CAUTION - Insert the CFast Card face up. - Screw holes may be damaged if screws are tightened with a torque greater than the specified torque.The specified tightening torque is 5 - 6kgfcm. - All specification is not guaranteed if you use any CFast except ones selected as our options. If you need any specification of BX-961D, you should use CFast selected as our options. If you want to close the hole of CFast Card without it, please install an attached cover as follows. * Please fix it using the screw shown above. * An attached screw (M3 x 8) Figure 3.2. Attaching the CFast Cover CAUTION Screw holes may be damaged if screws are tightened with a torque greater than the specified torque. The specified tightening torque is 5 - 6kgfcm. 12 BX-961D Series User’s Manual