Download USER`S MANUAL

2. Attach the four Base Pads (81) to the base of the Uprights
(85) in the indicated locations with four 1” Tek Screws
(82) and four Plastic Spacers (101). Note: One replacement Base Pad may be included. Use the Base Pad to replace any Base Pad that becomes worn.
2
101
81
82
With the help of a second person, carefully tip the treadmill down so the four Base Pads (81) are resting on the
floor and the Uprights (85) are in the vertical position.
101
85
101
55
81
82
101
3. Remove the band securing the Upright Wire Harness (73)
to the right Upright (85). Have a second person hold the
console assembly near the right Upright.
3
Console
Assembly
Connect the Upright Wire Harness (73) to the wires extending from the console assembly. Make sure to connect the
connectors properly (see the inset drawing). The connectors should slide together easily and snap into
place. If the connectors do not slide together easily and
snap into place, turn one connector and try again. IF THE
CONNECTORS ARE NOT CONNECTED PROPERLY,
THE CONSOLE MAY BE DAMAGED WHEN THE
POWER IS TURNED ON. Insert the connectors into the
right Upright (85).
4. With the help of a second person, set the console assembly on the Uprights (85). Make sure that no wires are
pinched. Attach the console assembly with four Console
Bolts (72) and four Star Washers (67) (only one side is
shown). Start all four Console Bolts before tightening
any of them.
73
85
73
4
85
67
Console
Assembly
67
72
7