Download MEA Amplifier for Upright Microscopes

MEA Amplifier for Upright Microscopes - User Manual
The following illustration shows the standard pin layout of the socket on the amplifier. The list
below shows the assignment of the electrodes to the pins of the socket. Pin 1 is the ground of
the power supply, pin 2 is the ground of the signal, that is, where the signal is referred to. Both
pins are already internally connected inside the amplifier.
Channels A1–A4 are the four additional analog inputs of the MC_Card that are not used by the
MEA amplifier.You can access channels A1–A3 via the BNC sockets labeled Analog IN on the
rear side of the data acquisition computer of the MEA-System (see also MEA-System User
Manual).
22