Download USER`S MANUAL

Transcript
ASSEMBLY
• Assembly requires two persons.
• To identify small parts, see page 6.
• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until you finish assembly.
• Assembly requires the following tools:
the included hex keys
one adjustable wrench
• After shipping, there may be an oily substance
on the exterior of the treadmill. This is normal. If
there is an oily substance on the treadmill, wipe
it off with a soft cloth and a mild, non-abrasive
cleaner.
one Phillips screwdriver
To avoid damaging parts, do not use power tools.
1.
Make sure that the power cord is unplugged.
1
Attach the Left Wheel Cap (96) to the Base (94)
with two #8 x 3/4" Screws (2).
Attach the Right Wheel Cap (not shown) to
the right side of the Base (94) in the same
way.
56
94
2
96
2.Pull the Upright Wire (81) and the base ground
wire (A) through the indicated hole in the
Base (94).
2
Attach the base ground wire (A) to the Base (94)
with a #8 x 1/2" Ground Screw (10).
Hole
Press the Grommet (77) into the square hole in
the Base (94).
Square
Hole
77
81
10
7
A
94