Download EADS / Racal 1261B Manual
Transcript
1261B User Manual -311,”Memory error” DDE The EMS’s memory is corrupted. -314,”Save/recall memory lost” DDE The *SAV or *RCL command has failed due to a corrupted nonvolatile memory. -315,”Configuration memory lost” DDE Configuration information has been lost due to a corrupted nonvolatile memory. -330,”Self-test failed” DDE The self-test has failed. If this is set at power-up, execute the *TST? query to determine what has failed. -350,”Queue overflow” DDE An attempt was made to add an error message to a full error queue. Thus, the error queue has overflowed. -360,”Communication error” DDE A communication error has occurred over the RS-232 interface. -361,”Parity error in program message” DDE A parity error has been detected in the command over the RS232 interface. -362,”Framing error in program message” DDE A framing error has been detected in the command over the RS-232 interface. -363,”Input buffer overrun” DDE The RS-232 interface input buffer has been overrun. -400,”Query error” QYE A query error has been detected. -410,”Query INTERRUPTED” QYE The query has been interrupted (see IEEE-488.2, Sec. 6.3.2.3). -420,”Query UNTERMINATED” QYE see IEEE-488.2, Sec 6.3.2.2 for a description. -430,”Query DEADLOCKED” QYE The query has reached a deadlocked state. This happens when the input buffer is full, the output buffer is full, and a reply to a query cannot be generated. 1000,”VXI signal queue overflow” DDE The signal queue has overflowed. Sending VXI signals is an alternative method of generating interrupts. 1001,”VXI interrupt queue overflow” DDE The queue of pending interrupts to send has overflowed. The EMS maintains a queue of interrupts which should be sent. An interrupt cannot be sent until a previous interrupt has been acknowledged. 1002,”VXI bus error” DDE A VXIbus error has occurred when the EMS attempted to write data over the VXIbus. 1003,”VXI bus timeout” DDE A timeout has occurred while the EMS was waiting for control of the VXIbus. 1005 - 1999, “Internal error: xxx” DDE An internal firmware error has been detected. Errors of this type should be reported to Racal Instruments for correction. Error Messages B-4 Racal Instruments Ó 1995 Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com