Download AUGERMATIC

10 Notes for mounting
Page 90
10.5 Feed hopper
When erecting the feed hopper make sure it is slightly inclined towards the
AM drive. This is important so that cleaning water does not stay in the lower
part of the feed hopper, thus possibly destroying the bearing of the tension
shaft.
)
Only one feed hopper (5) is required for both tube diameters 45 mm (1) and
50.8 mm (2).
A sleeve (3) is used to achieve this.
The sleeve (3) is installed as a transition at the Augermatic drive (4) for the
tube dia 45 mm (1) and at the feed hopper (5) for the tube dia 47.6 mm or
50.8 mm (2).
The sleeve dia 48x1.5-50 long for tube dia 45 and 47.6 Code No. 11 31
3547 and the sleeve 50x2,5-40 for tube dia 45/50,8, Code No. 83 00 4914
are comprised in the volume of delivery of the Augermatic drive.
Fig. 741.48
User and assembly manual AUGERMATIC
Edition: 11/2003 „ M 0742 GB