Download PT-8411G User Manual - Etec Components Limited

4.
Check the radio button to “Enable” or “Disable” the NAPT setting. Leave as its default setting if your
ADSL provider or ISP didn’t provide any setting information.
Note:
NAPT: Network Address and Port Translation: An extension of NAT, NAPT maps many
private internal addresses into one IP address. The outside network (WAN) can see this one
IP address but it cannot see the individual device IP addresses translated by the NAPT.
5.
Under the WAN IP mode, enter the “Local IP Address”, “Subnet Mask”, “Remote IP Address” and
“DNS” setting if you are using the Fixed IP (Or Static IP) mode. These information/data will be provided
by your ADSL Service provider or ISP.
6.
Check the radio button to “Enable” or “Disable” the Default Route setting. Leave as its default setting
if your ADSL provider or ISP didn’t provide any setting information.
7.
Click “Add” button after setup. The following screen display:
4 Ports 11g Wireless ADSL2/2+ Router
86