Download DIGITAL ELECTRONIC FLASHLIGHT
Transcript
HSK155_Manual_072505.qxd 7/26/05 4:01 PM Page 6 HSK155 RECHARGEABLE DIGITAL ELECTRONIC FLASHLIGHT IF YOU SHOULD EXPERIENCE A PROBLEM WITH YOUR HUSKY PURCHASE CALL TOLL FREE (800) 916-7004. IN MOST CASES A HUSKY SERVICE REPRESENTATIVE CAN RESOLVE YOUR PROBLEM OVER THE PHONE. KEY INFORMATION YOU SHOULD KNOW: • HALOGEN BEAM WITH POWER FAIL NIGHT LIGHT • 3 LEDs PROVIDE 15 HOURS OF CONTINUOUS RUN TIME • 4 RECHARGEABLE Ni-Cd BATTERIES INCLUDED • DIGITAL DISPLAY INDICATES CHARGE LEVEL AND RUN TIME REMAINING • AC CHARGER AND DOCK-MOUNT CHARGING STATION INCLUDED USER’S MANUAL AND WARRANTY INFORMATION THIS MANUAL CONTAINS IMPORTANT INFORMATION REGARDING SAFETY, OPERATION, MAINTENANCE AND STORAGE OF THIS PRODUCT. READ CAREFULLY BEFORE USE, AND RETAIN FOR FUTURE REFERENCE. © 2005 VECTOR MANUFACTURING MADE IN CHINA 6 4140 S.W. 30th Ave., Ft. Lauderdale, FL 33312 Toll Free: (800) 916-7004 HSK155_Manual_072505.qxd 7/26/05 4:01 PM Page ii Congratulations on selecting the Husky Digital Electronic Flashlight. • Ideal for temporary power outages or emergencies - always be prepared! • Built-in 3 LED long lasting area light on handle • LCD digital display shows charge level and run time remaining • Dock-mount charger - Fully automatic • Operates on 4 rechargeable Ni-Cd batteries (included) • Power fail night light • Break resistant “O” ring sealed polycarbonate lens WARNING: PLEASE READ AND UNDERSTAND ALL INSTRUCTIONS. OPERATION AND SEQUENCING The Digital Electronic Flashlight is sequenced. The flashlight will react differently with each press of the ON/OFF pushbutton. • 1st Press: Halogen beam is ON; digital display shows how much run time remains and battery charge level. • 2nd Press: 3 built-in LEDs are ON and digital display shows how much LED run time remains and battery charge level. (LED run time displays only when LED is on.) • 3rd Press: All lights are OFF. • Press and hold (2 seconds): All lights are ON. Charging time is approximately 2.2 - 2.5 hours. Display will show LO when batteries are low and beep 3 times. The low battery symbol will also flash and light will shut off. BULB REPLACEMENT 1. Twist to unlock the Rubber Guard Cover from the Retaining Ring (Figure 2). 2. Gently remove the Retaining Ring, Lens, “O” ring and Reflector and put aside. 3. Twist counterclockwise and remove Halogen bulb from socket. 4. Replace halogen bulb with HR53, 5.2v, 0.8 amps bulb, available through Husky Technical Support. NOTE: This device complies with part 15 of FCC rules. Operation is subject to the following conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. ii 1 HSK155_Manual_072505.qxd 7/26/05 4:01 PM Page 2 LOW BATTERY ALARM A low battery alarm will sound once every 5 minutes for a total of 12 times within 1 hour, to remind you to recharge your flashlight. 1 BATTERY DISPOSAL Dispose of used batteries properly. For more information on recycling batteries, please call toll free (800) 822-8837. 4 5 7 6 Figure 1. Digital Electronic Flashlight RECHARGING The charging adapter rating is 7.2 volts, 500mA. The charging time for the flashlight is approximately 2.2 - 2.5 hours. While charging the LCD display will show CH, the battery symbol will flash. The flashlight is fully charged when the battery symbol stops flashing. If there is a power failure during charging, the LCD display will show PF and the night light will flash. NOTES: Flashlight can be recharged only if rechargeable type batteries are used. Alkaline and standard batteries are not rechargeable. To recharge: Place flashlight in wall mounted holder, attach recharger to flashlight recharge port and plug into wall receptacle. Digital display accuracy will be affected if unit is near full discharge level, display will not read accurate remaining run times unless unit has at least a minimum required charge level. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: - Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. - Connect the equipment to an outlet on a circuit different from that to which the receiver is connected. - Consult the dealer or an experienced radio/TV technician for help. 2 3 2 BATTERY REPLACEMENT Occasionally, even rechargeable batteries need replacing 1. Remove screw at the base of battery cover. 2. Pull gently up on the battery cover to remove. 3. Remove and replace 4 rechargeable batteries. 4. Replace batteries in same position as removal. 1 2 3 4 5 6 7 Halogen Beam Screw 3 LEDs Recharge Port Battery Cover ON/OFF Pushbutton LCD Digital Display Figure 2. Lens Assembly Lens Rubber Guard Cover Twist Out Bulb Reflector Rubber “O” Ring Retaining Ring 3 HSK155_Manual_072505.qxd 7/26/05 4:01 PM Page 4 HUSKY 1-YEAR LIMITED WARRANTY PROGRAM The Home Depot warrants this Husky Power Product to the original user to be free from defects in materials and workmanship for a period of two years from the date of purchase. If you believe that this unit is defective during its original two-year warranty period, return the unit with proper proof of purchase to the Home Depot store or you may send the product to Husky Power Products at the address below. This Husky Power Product is warranted, to the original purchaser only, to be free of defects in materials and workmanship for two years from the date of purchase without additional charge. The warranty does not extend to subsequent purchasers or users. Husky Power Products will not be responsible for any amount of damage in excess of the retail purchase price of the product under any circumstances. Incidental and consequential damages are specifically excluded from coverage under this warranty. This product is not intended for commercial use. This warranty does not apply to accessories or damage to units from misuse or incorrect installation. Misuse includes wiring or connecting to improper polarity power sources. RETURN/REPAIR POLICY: Defective products, other than accessories, may be returned to Husky. Any defective product, other than accessories, that is returned to Husky Power Products within 30 days of the date of purchase will be replaced free of charge. If such a product is returned more than 30 days but less than two years from the purchase date, Husky Power Products will repair the unit or, at its option, replace it free of charge. If the unit is repaired, new or reconditioned replacement parts may be used, at Husky Power Product’s option. A unit may be replaced with a new or reconditioned unit of the same or comparable design. The repaired or replaced unit will then be warranted under the terms of the remainder of the warranty period. The customer is responsible for the shipping charges on all returned items after 30 days. During the warranty period, Husky Power Products will be responsible for the return shipping charges. If your problem is not covered by this warranty, call our Technical Support Department at (800) 916-7004 for general repair information and charges if applicable. STATE LAW RIGHTS: This warranty gives you specific legal rights. Some states do not allow limitations on how long an implied warranty lasts or the exclusion or limitation of incidental or consequential damages, so the exclusions or limitations stated herein may not apply. This warranty gives the purchaser specific legal rights; other rights, which vary from state to state, may apply. TO REQUEST WARRANTY SERVICE FOR THIS PRODUCT: Contact Husky Power Products Technical Support by telephone or mail. We suggest that you keep the original packaging in case you need to ship the unit. When returning a product, include your name, address, phone number, dated sales receipt (or copy) and a description of the reason for return and product serial number. After repairing or replacing the unit, we will make every effort to return it to you within four weeks. WARRANTY ACTIVATION: Please complete Warranty Activation Card and mail to Husky Power Products. Enter “HSK155” as Model and “Rechargeable Digital Electronic Flashlight” as Product Type. All Husky Power Product products must be registered within 30 days of purchase to activate this warranty. Mail the completed registration form, along with a copy of the original sales receipt to: ATTN.: CUSTOMER SERVICE / HUSKY POWER PRODUCTS 4140 SW 30th Ave., Ft. Lauderdale, FL 33312 TOLL FREE: (800) 916-7004 WARRANTY IS NON-TRANSFERABLE AND NON-REFUNDABLE LIMITATIONS: This warranty does not cover accessories, bulbs, fuses and batteries, defects resulting from normal wear and tear (including chips, scratches, abrasions, discoloration or fading due to usage or exposure to sunlight), accidents, damage during shipping to our service facility, alterations, unauthorized use or repair, neglect, misuse, abuse, failure to follow instructions for care and maintenance, fire, flood and Acts of God. BD072505 4 5