Download User Manual - Gerald Simonds

0textunit UM05_en_Champion.doc
6.3 Aligning the front wheel
6.4 Adjusting the backrest
After adjustments which influence the seat height or the
seat angle, the axis of the bearing block must be aligned
vertically to the floor again.
Adjusting the height
The height of the standard backrest with push-handle can be
adjusted in steps of 15 mm.
Figure 33
Figure 32
Push up the backrest cushion until the bolt
is visible
Loosen the bolts at the bearing block
Loosen the bolt and move the backrest to the required
height
Insert the upper excenter into the required position (further
at front or rear side, depending on the seat angle)
Insert the bolt in the hole which is closest and tighten it
again.
Turn the lower excenter (with bolt inserted) until the axis of
the bearing block is aligned vertically to the floor
Tighten both bolts again.
0
Adjustments carried out by the authorized dealer
29