Download Untitled

7 SPECIFICATION
Frequency Response20 Hz - 20 kHz ± 0,15 dB
8 Ω load, 10 dB below rated power
Input Impedance 14 kΩ balanced
Voltage Gain selectable: 26 dB, 32 dB, or 1,4 V input sensitivity
Protection Circuitsinrush-current limitation, temperature monitoring of transformer and heat-sinks,
output DC protection, power transistor SOA protection, output over current protection,
mains fuses protection
Limiter switchable clip limiter
Fan temperature dependent speed-controlled axial fan
Ground Lift input ground lift switch on back panel
IndicatorsLEDs for Mode, Signal, Clip, Output Current and faults for example like DC
Input Connectors 3-pin XLR, male and female per channel, pin 2 = inphase (hot)
Output Connectorsone 4-pole SPEAKON connector for each output channel (bi-amping possible)
Modes of Operation Stereo, Mono-Bridge and Parallel-Mono
Options Extended User Interface / E.U.I. 2 – modules for any kind of EQ
THD+N (typical) < 0,01 %
20 Hz - 10 kHz, 8 Ω load,
10 dB below rated power
SMPTE (typical)
8 Ω load,
10 dB below rated power
Damping Factor
8 Ω load, 1 kHz and below
Dimensions (WxHxD)
Net Weight
Shipping Dimensions (WxHxD)
Shipping Weight
P.25
USER MANUAL
TECTON POWER AMP SERIES
< 0,01 %
> 400
483 x 88,9 x 330,7 mm (19”, 2U)
9,4 kg
540 x 135 x 540 mm (0,04 m3)
11 kg
Subject to technical alterations without prior notice