Download HiPER 840G

UTT Technologies
Chapter 5 Network
The connection is disconnected due to that the interface is disabled or
Disconnected
not connected, etc.
The connection is established between the Gigabit Router and peer
Connected
device.
Table 5-2 Description of Static IP Connection Status
3.
DHCP Connection Status
For the DHCP connection, there are two kinds of status, see Table 5-3. When it is
connected, it will also display the elapsed time (days: hours: minutes: seconds) since
connected.
Status
Description
The connection is disconnected due to that the interface is disabled or
not connected, or the Gigabit Router has released the IP address but
Disconnected
hasn’t obtained a new one yet, etc.
The Gigabit Router has obtained an IP address, and the connection is
Connected
established successfully.
Table 5-3 Description of DHCP Connection Status
4.
3G Connection Status
For the 3G connection, there are two kinds of status, see Table 5-4. When it is
connected, it will also display the elapsed time (days: hours: minutes: seconds) since
connected.
Status
Disconnected
Connected
Description
The connection is disconnected due to that the 3G USB modem isn’t
inserted properly, or wrong ISP, 3G USB modem settings, etc.
The Gigabit Router has obtained an IP address, and the connection is
established successfully.
Table 5-4 Description of 3G Connection Status
IP Address, Subnet Mask and Default Gateway: They display the current IP
settings of the connection. There are two cases:
●
For the PPPoE, DHCP or 3G Internet connection, it will show the current WAN IP
address, subnet mask and gateway IP address which are assigned by your ISP.
●
For the static IP Internet connection, it will show the information you have
entered manually.
http://www.uttglobal.com
Page
3232