Download Emineo Owner`s Manual

HIP BELT
Fitting the hip belt (accessory)
Figures 51, 52 and 53
• Remove the seat cushion and loosen
the backrest cover. For easier access
when fitting the hip belt, loosen the four
screws in the seat plate and pull the
seat forward (use a 4 mm Allen key)
• Fit the mounting brackets to the hip belt.
Use a 5 mm Allen key and a 13 mm
wrench, and screw in the screw (52A)
and nut (52B). Repeat on the other side
Figure 51
• Thread the seat belt through the
brackets and under the seat plate
27
B
• Push the seat plate back to its original
position and re-tighten the screws in the
seat plate
A
Figure 52
Figure 53