Download CNC 800T USER

8.
MACHINING CANNED CYCLES
This CNC offers the following machining canned cycles:
G67 N0
G67 N1
G67 N2
G67 N3
G67 N4
G67 N5
G67 N6
G67 N7
G67 N8
G66
G68
G69
G81
G82
G84
G85
G86
Turning.
Facing.
Taper turning
Threadcutting
Rounding
Grooving
Multiple drilling
Simple drilling/tapping
Slot milling along X or Z
Pattern repeat (not accessible from the keyboard)
Stock removal along X (not accessible from the keyboard)
Stock removal along Z (not accessible from the keyboard)
Turning of straight sections (not accessible from the keyboard)
Facing of straight sections (not accessible from the keyboard)
Turning of curved sections (not accessible from the keyboard)
Facing of curved sections (not accessible from the keyboard)
Longitudinal treadcutting canned cycle (not accessible from the keyboard)
Parameters related to the canned cycles:
The canned cycles may alter the values of parameters P0 through P99.
On power-up, after a Reset and every time the execution mode of P99996 is quit, the CNC
updates (resets) the following arithmetic parameters:
P190
P191
P201
P24
X coordinate of the tool change position set by the machine manufacturer.
Z coordinate of the tool change position set by the machine manufacturer.
Work units (0 = mm, 1 = inches).
Work units (0 = Radus, 1 = Diameter)
When programming the canned cycles, if the value being assigned to a parameter is a
constant, write "K" after the "=" sign. For example: N4 G66 P0 = K25 ......
Chapter: 8
MACHINING CANNED CYCLES
Section:
Page
1