Download Installation & User Guide with Quick Start

Installation & User Guide with Quick Start– Models: MC-30/38, MC-60/68
1. Install USB driver. See “README‐Sensera‐MC30‐MC60.pdf” on the orange USB thumb drive for instructions to install the USB driver. This step may require administrator privileges on your PC. 2. Remove the USB cable from the wall charger and connect to a Windows PC 3. On the orange USB thumb drive, navigate to the application file “USBConfig.exe application” and double click to launch. 4. A windows application will launch. 5. Click “WiFi” to select WiFi network interface 6. Enter SSID of the WiFi network you want to connect to. 7. Enter the password for the SSID you entered 8. NOTE: at this point you may enter additional WiFi/SSID pairs for additional networks. This will allow you to later run the USBConfig.exe application tool to quickly change between these networks without entering SSID/password information. 9. Confirm that the status shows “Connected”. If not, please see Troubleshooting section. 10. Click “Finished” 4.2
Create User Account
A User Account is required in order to access your cameras via the WebApp. The User Account ensures that only you can access your cameras or data. To create a User Account: 
Navigate to the WebApp Login page 
Choose “Create a new Sensera WebApp Account” (bottom of panel) 
Fill in an email address (this is your username and is used for alerts about the account and to retrieve your password) 
Choose a Password 
Click “Create Account” Page 19 of 47 www.SenseraSystems.com