Download SetGoldPro User Manual

Transcript
Appendix B
Editing default values for targets
B.1 Introduction
This appendix describes how to edit some default values used for generating targets in
SetGoldPro. The default values that you can edit are mainly associated with Gray Balance targets, although you can edit the color of dividing lines on all targets.
The default values used for generating targets are defined in a PostScript dictionary in
the defaults.lg file, located in the data folder within your SetGoldPro application
folder. Values within this dictionary are expressed as key-value pairs, which include a
key that begins with a forward slash, such as /IterationPrefix and a value such as
Greybal.
Note: If you edit the defaults.lg file and wish to return to the default values, delete
the defaults.lg file and restart SetGoldPro. SetGoldPro will create a new
defaults.lg file with default values if no existing file is found.
B.2 Editing the Gray Balance target
There are two main aspects of the Gray Balance target that you may edit:
Percentages
SetGoldPro 4.0 User Manual
You can change the percentage values of the patches for all
the strips. See “Percentage values” on page 70 for details.
AG50529 Rev. 7
69