Download Instruction Manual

Troubleshooting
Possible problem
No power. Power
blue LED is not on.
Power cord is not plugged in or is not completely inserted.
Firmly plug in the power the power cord.
Wall adapter is not plugged into the unit correctly.
Check connection of wall adapter.
Wall adapter is not receiving AC power.
Place wall adapter in a known powered outlet. Test outlet with a lamp
or other device.
Remote control power button is not depressed.
Press power button located at the remote control Blue LED will illuminate.
No power to system.
Ensure power supply is connected to live power source and properly connected
to speaker.
No sound from
speaker system.
Crackling sound
from speakers.
Sound is distorted.
Radio interference.
10
Solution
Symptom
No volume or low volume.
Turn the volume "+" knob on the volume control to increase the system volume level.
Input source is low.
Increase the volume level on the audio source device.
Input select is not correct.
Ensure input select is in LINE1 , LINE2 or LINE3 input connect.
Line input select is not correct.
Ensure Line input select is in LINE1 , LINE2 or LINE3.
Bad connection.
Check connection of the stereo cable.
Make sure it is connected to " line-out" "audio-out"
or the headphone jack on your audio source-and
NOT "speaker-out".
A problem with your audio source.
Unplug the stereo cable form the audio source. Then plug it into the
headphone jack or an alternate source.(e.g., CD player, Mp3 player)
Volume level on speaker system is set too high.
Please to decrease the volume.
Sound source is distorted.
WAV and MID files are often of poor quality ;therefore distortion and noise are easily
noticed with high-powered speakers. Try a different audio source such as a music CD.
Too close to a radio tower.
Move your speakers to see if interference goes away.