Download Installation & operating instructions DPHM

Transcript
Problem
Possible cause
Pump supplies insufficient Pump sucks air because
capacity and/or pressure. of leakage in the suction
line.
Water flow too low. So air
bubbles clog up in the
pump.
The diameter of the suction line is too small.
Capacity of water meter in
the supply line is too
small.
Leakage.
Pump failure.
10.2
Torques of vent and draining
plugs
18
Dimensions
Torques
[Nm]
PEHD
G 1/4
3
AISI
G 1/4
15
Figure
Material
Table 9: Torques
Locations E and F in
fig. 3 DPHM(C) 2/4/6
Possible solution
Repair the leakage.
Make sure the flow
increases or use a smaller
pump.
Increase the diameter of
the suction line.
Increase the capacity of
the water meter.
Contact the supplier.
Checkpoints