Download - TDK

MODEL KEY
FOR DIFFERENT
OUTPUT VOLTAGE
MODELS.
13.0 TYP x2
SEE NOTE 2.
MODULE "A"
60.8
MODULE "B"
A
MODULE "C"
10.7
466.2 ±1.0
483.0 ±1.0
445.0 ±1.0
PMBUS ADRESS
SEE NOTE 4.
273.8
A
88.5
14.0
4. REFER TO INSTRUCTION MANUAL FOR SETTING DETAILS.
5. MODEL NAME, VOLTAGE AND CURRENT RATING AND
SAFETY APPROVALS SYMBOLS WILL BE SHOWN HERE
ACCORDING TO THE SPECIFICATION.
6. USE UL APPROVED INSULATED TERMINAL LUGS.
7. THE HFE-S1U RACK IS SHOWN WITH 4 HFE2500
UNITS INSTALLED.
A
HOLES FOR BLANK
PANEL MOUNTING.
USE FLAT HEAD SCREW
M3x6 8 PLACES
MARKED "A"
NOTES
1. MOUNTING HOLES FOR RACK 19". USE M6x12 SCREWS TO FIX THE
UNIT TO A RACK.
2. USE NUT,FLAT WASHER AND SPRING WASHER FOR LOAD WIRES
FIXING. USE LUG STUD M6 FOR LOAD WIRES.RECOMMENDED
TORQUE: 42-56 Kgf.cm
3. TO FIX THE MOUNTING BRACKET TO THE CHASSIS USE M5x10 SEMS
SCREWS .RECOMMENDED TIGHTENING TORQUE 27~31Kgf.cm.
SCREWS MUST NOT PENETRATE THE CHASSIS MORE THAN 6.0 mm.
24.5
13.0 TYPx2
+0.4
43.6 0.0
15.0 TYP x2
333.0 TYP x2
22.0 TYP x2
2.0
82.7
10.0
M5 HOLES FOR
17.0 TYPx2
MOUNTING BRACKETS.
4 PLACES
SEE NOTE 3.
OUTPUT
BUS BAR "-V"
OUTPUT
BUS BAR "+V"
409.0 1.0
11.0
15.5 TYP
125.8
A
MODULE "D"
MODULE "C"
MODULE "D"
1
39
10.0
10.0
SEE NOTE 6.
SEMS SCREW M4
RECOMMENDED TORQUE
14~16Kgf.cm
TB CONNECTOR
SIGNALS & CONTROL CONNECTOR PINS ASSIGNMENT
2
40
AIR FLOW
DIRECTION
CONNECTOR DESCRIPTION: IPLT1-120-01-L-D-RA-K(SAMTEC)
MATING CONNECTOR: IPD1-20-D-K (SAMTEC)
MODULE "B"
SEE NOTE 5.
MODULE "A"
16.0 TYPx2
SEE NOTE 1.
14.0 TYPx2
OUTPUT
BUS BAR "-V"
OUTPUT
BUS BAR "+V"
426.5 ±1.0
1.2
6.0
19
31.7
214.5
HFE2500 - S1U-TB Outline Drawing