Download User Manual - Projector Central
Transcript
+ 0 ID SET CLEAR AV-MUTE FREEZE MENU EXIT G MA NI Adjusting with the remote control PA FY L-CLICK 1. Press the KEYSTONE button. GE ENTER 3. Projecting an Image (Basic Operation) MOUSE R-CLICK ECO MODEKEYSTONEPICTURE The Keystone bar will be displayed. HELP FOCUS ASPECT VOL. ZOOM 2. Use the or button to correct the keystone distortion. Adjust so that the right and left sides are parallel. ON POWER OFF AUTO ADJ. COMPUTER 1 2 VIDEO 3 S-VIDEO VIEWER 4 5 7 8 6 9 0 CLEAR + ID SET AV-MUTE FREEZE MENU EXIT G MA NI GE ENTER PA FY L-CLICK MOUSE R-CLICK ECO MODEKEYSTONEPICTURE 3. Press the ENTER button. ON POWER OFF AUTO ADJ. HELP FOCUS ASPECT VOL. COMPUTER ZOOM 1 2 VIDEO 3 S-VIDEO VIEWER 4 5 7 8 6 9 0 CLEAR + ID SET AV-MUTE FREEZE MENU EXIT G MA NI GE ENTER PA FY L-CLICK MOUSE R-CLICK ECO MODEKEYSTONEPICTURE HELP FOCUS ASPECT VOL. NOTE: ZOOM • The Keystone correction can cause an image to be slightly blurred because the correction is made electronically. • The maximum range of vertical keystone correction is +/−40 degrees. This maximum range may be smaller depending on the signal or aspect ratio setting. The Keystone correction range will also be smaller when 3D mode is enabled. • The range of keystone correction is not the maximum tilt angle of projector. • The left and right (horizontal) keystone correction is not available. TIP: The changes can be saved with [KEYSTONE SAVE]. (→ page 55) 25