Download LRC-Small

Installation of the LRC-Charger:
The amplifier is already integrated in the LRC-Charger.
This is not approved for the Ex-zone, therefore it has to be
installed inside the driving cab or inside the box
where the printer is installed resp. inside an external
box.
From practical experience a location next to the co-driver´s
seat is suitable.
Mounting
plate
Grundplatte
The LRC-Charger has to be mounted vertical or nearly
vertical to prevent contact-problems because of
vibrations during driving.
The mounting-plate is fixed with 4 screws. Please, take care,
that the screws are fixed firmly to resist the vibrations in
the tank truck and the mechanical burden on plugging-on and
plugging-off the LRC-Small.
Take into consideration to keep room below the unit to connect
the cable and above the unit to plug-in the LRC-Small.
Bohrungen 5mm
Drilling holes
5 mm
After having built-in the mounting-plate, plug the LRC-Charger with the nose into the hole in
the mounting-plate and press the base-part against the mounting-plate. Fix afterwards the
LRC-Charger by using the tooth wheel and the M3-screw.
Service- and User-Manual
-B1-
Security & Electronic Technologies GmbH