Download User Manual - NETAVIS Observer
Transcript
NETAVIS Observer 4.6 User Manual (October 2015) Field label Bandwidth limit (Kbps) Description This setting limits the maximum bandwidth in kilobits per second for the transmission of MPEG streams between the camera and the server. As a consequence, also the bandwidth between the server and the clients is thus limited and also the required storage in the archive is influenced (limited). If this value is zero, then the bandwidth is not limited. This actually is a setting in the camera. The camera always optimizes for the desired image quality and will sacrifice frame rate in favor of quality in the case, the bandwidth would exceed the supplied limit. Fields for In-camera motion detection (please refer to 8.3 In-camera motion detection on page 90 for further details): Field label Description Receive event images via FTP If this checkbox is marked, you enable the In-camera motion detection and tell Observer to receive event images via FTP. Please be aware that if you select this checkbox, the server-based motion detection must be disabled. Receive event images via HTTP The same as above, just that the images are received via HTTP protocol (some cameras support only HTTP). Post recording length (sec) When Observer receives an in-camera event, then it can start a parallel server-side recording in addition to the event images it receives from the camera. The event images received from the camera via HTTP (FTP is not supported with this option) are merged with this server-side recording. This field defines how long this parallel post-event recording is. If it set to 0, then Observer does not start its own server-side recording of images and just stores the event images it receives from the camera via FTP/HTTP. Frame rate This field defines the frame rate of the above mentioned parallel server-side post-event recording. 5. Push the Next button at the bottom of the dialog. This invokes the Scheduling dialog. Please refer to 7.1 Programming archive recordings on page 71 on how to set up the camera archive and scheduling. 6. Optional: Push the Next button again at the bottom of the dialog. This invokes the I/O Control dialog that lets you define the handling of optional I/O contacts of your camera. If you do not want to use I/O contacts you can just jump to the next step. Page 37 of 204