Download NMS SNMP Reference Manual

TOC
IDX GLS
Chapter 2 Installing and Activating SNMP
NMS SNMP Reference Manual
h. In the Security tab, you can modify the access rights.
i. When you are finished, click OK.
5. Open a command prompt window.
6. Enter the following to start the SNMP service:
net start snmp
7. Enter the following to start the SNMP trap service:
net start snmptrap
The SNMP trap service is not required if you use only NMS subagents.
However, you will need it if other standard subagents are attached to the
master agent.
8. Enter the following to verify that the master agent is properly installed:
netstat –a
If the master agent is installed properly, the following appears:
UDP
UDP
snmplab_3:snmp-trap
snmplab_3:snmp
*:*
*:*
If you receive an error, it may mean that you did not reinstall the NT service
pack after installing the SNMP service. Reinstall the service pack.
9. Verify that the SNMP master agent is properly installed.
To do so, you can use any SNMP management station. You can also use the
snmpwalk demonstration program (installed with the SNMP package) to
enumerate the contents of the Mib II agents.
10. Install the NMS subagents and multiplexer as described in Section 2.3.
Note: Make sure to add the installed components to the registry as
described in Section 2.3.1.
34
NMS Communications
Send Feedback to NMS Doc Dept