Download VFD Series - American Control Electronics

Transcript
VFD Series
Boost (BOOST)
The BOOST trim pot is used to increase motor torque at low speeds. The
minimum setting is sufficient for most applications and does not need
to be adjusted. If the motor stalls or runs erratically at very low speeds
(below 10 Hz), the boost trim pot may need adjustment.
To calibrate BOOST:
1.
Run the motor at the lowest continuous frequency/speed
required.
2.
Monitor the motor phase current (with a true RMS meter) while
very slowly turning the BOOST trim pot CW until the motor
operates properly, or 100% of the motor nameplate current is
reached.
Use the absolute minimum amount of BOOST necessary to
NOTE: U
achieve proper motor operation. Improper use of the
BOOST feature may cause motor and/or drive overheating
and failure.
28