Download SuperPro6100 Operation manual Guide

SuperPro

®
6100 Programmer
When you program the chip, the software will conduct the statistical activities
about the programming status automatically or according to the user’s setting. It is
only effective for the function “program” by default. You can change the default
setting in the above window.
Note: Some minor changes should be made for the above description if the devices in
the Operation Option are selected in some ways. For example, most single-chip
microcomputers do not allow the user to change the start address of the device. The
auto serial number function can not be used in the stand alone mode.
4.1.4.2 Edit Auto
In the window of “Function Items for Operations on Devices”, all devices have an
Auto option. The Auto function is used to organize the different functions of the
device into a sequential group and carry out the functions according to the order. It is
just similar to a batch command. For example, select ATMEL AT89C51, open Edit
Auto dialogue box. On the left of the box is Device Functions column in which all
device operations are displayed. On the right of the box is the Auto column in which
the operations to be performed and the operation execution order are displayed.
1296 Kifer Rd. Suite #605
Sunnyvale, CA 94086
www.xeltek.com
[email protected]
Tel: +1 408-530-8080
Fax: +1 408530-0096
42 / 64